Packaging design and manufacturing service provider
NEWS

Basic Knowledge About Some Products Of Beyaqi Lotion Pump

Views: 228     Author: Site Editor     Publish Time: 2022-06-16      Origin: Site

Basic Knowledge About Some Products Of Beyaqi Lotion Pump

Lotion pumpis generally used for shampoo, shower gel, hand sanitizer and other products on the packaging.

Our company divides this category into screw pump lotion pump, left and right lotion pump and big lotion pump.

The screw lotion pump is called 2CC lotion pump in the market, Left and right pump product market said 1.5CC lotion pump, big lotion pump market said 4CC lotion pump, usually need to press 3-5 times to normal water.

1. The pump body and gasket of 24/410 and 28/410 are different, and others can be used.


Big lotion pump sizes will also be 33/410, 38/410 and so on.


24mm and 28mm refer to the inner diameter of the large circle:(As shown in the figure)

foam pump

400,410,415 refers to the large circle height, measured with calipers.(As shown in the figure)

24 410 foam pump

2. normally, the pump body and piston bar do transparent color.


3. ball valve stainless steel can replace ball valve glass, and it is better to use, and belongs to environmental protection. But Screw pump and big lotion pump may be used in some liquid too sticky products, ball valve glass are too light, resulting in the second time when the suction will not suck, so we can use ball valve stainless steel (5mm) to replace our ball valve glass, and better use, belong to environmental protection.


4. The tube of the pump is usually PE tube, not PP hard tube.


5. Left and right lotion pump has only one ball valve glass. Screw pump and lotion pump market also exists with a bead manufacturers, Beyaqi will use two ball. The advantage is that the water is fast, the suction is stronger, but the cost is high.


6. Gasket to 1.2mm as standard, 2.0mm/1.5mm can also be made.


7. conventional spring is 304H, can also do 316L(better environmental protection, corrosion resistance and strength).

After the product is finished, we will check whether the product appearance, size, straw length and other details are consistent with the requirements of the customer. Check whether the suction is good. Test whether the screw (switch) can be opened easily. To ensure the good quality of products.